Pocket holds and concealed fixings from Holdfast

INSET POCKET HOLDS

Inset pocket holds These holds can be supplied either as front or back fitting versions and are intended for use on plywood boards. They provide a better representation of pockets than outset bolt-on holds.

 

1. Front fitting These holds can be fitted at any time to existing ply-faced structures providing there is 50mm of clearance behind the panel. They come with an integral composite flange which is screwed to the panel face. Simply create a hole slightly larger than the barrel (60, 75 or 100mm diameter), feed in the hold and secure the flange. Great accuracy is not required provided that you keep well inside the screw points and a jigsaw or padsaw is fine. We currently have 10 patterns: two 2-finger, four 3-finger and four 4-finger pockets. SET OF 10 £80

2. Back fitting Here you need access to the rear of the panel and a bit more work is required but the advantage is that no fixings are visible from the front.   Inset pocket hold 75mm diameter £7.95 each Inset pocket hold 100mm diameter £9.95 each

STUD-FIXED OUTSET HOLDS

Holds with an encapsulated stud (M10) so that no fixings are visible from the front. Applicable to installations where access to rear of panel is available at the build stage and ideal for people who need to fit and leave the site for others safe in the knowledge that holds are secure. Benefits include better aesthetics and tamper proof if access to rear is denied. Holds are supplied with “Nyloc” nuts/washers and are rubber backed as standard.

Stud-fixed outset holds SET OF 20 £68.50 click here for a bigger image

 

 

return to top of page